Owner`s manual

to the HomeLinkT Transmitter, but does not
open your garage door, and your garage door
opener was manufactured after 1995, your
garage door opener may have a ‘‘Code
Protected’’ or ‘‘Rolling Code’’ feature. This type
of system will change the ‘‘code’’ of your
garage door opener every time you open or
close your garage door.
To determine if you have one of these
systems, depress the button on the
HomeLinkT Transmitter that you have just
programmed. If the LED on the HomeLinkT
Transmitter flashes rapidly for 1 to 2 seconds,
then remains on, your garage door opener has
a rolling code system.
To operate your ‘‘Rolling Code’’ garage door
opener from your HomeLinkT Transmitter,
follow these steps:
1. Program your hand held transmitter to the
HomeLinkT Transmitter by following the
procedures outlined above (if not yet pro-
grammed).
2. Program your garage door opener receiver
to recognize your HomeLinkT Transmitter
(The HomeLinkT Transmitter follows the
same procedure to train to the receiver as
your hand held transmitter did when it was
first installed):
a) Remove the cover panel from your
garage door opener receiver. The
receiver should be located by the
garage door opener motor.
b) Locate the training button on the
garage door opener receiver. The
exact location and color of the button
may vary by garage door opener
brand. If you have difficulty locating
the training button, reference your
garage door opener manual. If you
have difficulty programming your ga-
rage door opener equipped with a
rolling code system to recognize the
HomeLinkT Transmitter with the
‘‘Rolling Code’’ feature, call INFINITI
Consumer Affairs Department.
c) Press the training button on the ga-
rage door opener receiver for 1 to 2
seconds.
d) Return to the HomeLinkT Transmitter
in the vehicle, and depress the pro-
grammed HomeLinkT button for the
duration of the fast blink on the
HomeLinkT Transmitter (1 to 2 sec-
onds). Release the button, and re-
press to confirm that the system has
trained.
e) Your garage door opener should now
recognize your HomeLinkT Transmit-
ter. You may use either your
HomeLinkT Transmitter or your
original hand held transmitter to open
your garage door.
INSTRUMENTS AND CONTROLS
1-38
Z 96.12.20/ X