Owner`s manual

CLEARING THE PROGRAM-
MING INFORMATION
Should you sell your vehicle, be sure to clear
the channels of the Integrated HomeLinkT
Transmitter. To clear the channels, simulta-
neously hold down the outside two buttons
(#1 & #3) until the red indicator light begins
to flash rapidly (approximately 20 seconds).
This will clear all three buttons. Individual
buttons cannot be cleared, but can be repro-
grammed at any time by following the pro-
gramming procedures described above.
IF YOUR VEHICLE IS EVER
STOLEN
If your vehicle has been stolen, you should
change the codes of any device that
was programmed into the Integrated
HomeLinkT Transmitter as soon as possible.
Consult the owners manual of each device, or
call the manufacturer or dealer of those
devices.
When your vehicle is recovered, you
will need to reprogram the Integrated
HomeLinkT Transmitter with your new
transmitter information.
FCC Notice:
This device complies with FCC rules
part 15. Operation is subject to the
following two conditions: (1) This de-
vice may not cause harmful interfer-
ence and (2) This device must accept
any interference that may be received,
including interference that may cause
undesired operation.
The transmitter has been tested and
complies with FCC and DOC/MDC rules.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s au-
thority to operate the device.
DOC: ISTC 1763K1313
FCC I.D.: CB2V67690
INSTRUMENTS AND CONTROLS
1-39
Z 96.12.20/ X