Owner`s manual

the automatic locking mode. When the cinch-
ing mechanism is activated the seat belt
cannot be withdrawn again until the seat belt
tongue is detached from the buckle and fully
retracted. Refer to ‘‘Child Restraint Systems for
Infants and Small Children’’ later in this
section for more information.
The automatic locking mode should be
used only for child seat installation.
During normal seat belt use by a pas-
senger, the locking mode should not be
activated. If it is activated it may cause
uncomfortable seat belt tension.
Unfastening the belts
To unfasten the belt, press the button on the
buckle. The seat belt will automatically retract.
Checking seat belt operation
(3-point type with retractor)
Your seat belt retractors are designed to lock
belt movement by two separate methods:
1) When the belt is pulled quickly from the
retractor.
2) When the vehicle slows down rapidly.
You can check their operation as follows:
O Grasp the shoulder belt and pull quickly
forward. The retractor should lock and
restrict further belt movement.
If the retractor does not lock during this check
or if you have any question about belt
operation, see your INFINITI dealer.
Shoulder belt height adjustment
(For front seats)
The shoulder belt anchor height should be
adjusted to the position best for you. (See
‘‘Precautions on seat belt usage’’.)
To adjust, squeeze the release buttons, and
then move it to the desired position, so that
the belt passes over the center of the shoul-
der. The belt should be away from your face
and neck, but not falling off of your shoulder.
WARNING
After adjustment, release the button
and check that it does not move up
and down to make sure the
SIP0167
PRE-DRIVING CHECKS AND ADJUSTMENTS
2-34
Z 96.12.20/ X