User`s manual

7-2 QX Hawk Industrial Imager User’s Manual
Serial Utility Commands
Serial Utility Commands
Note: For a list of all K commands, see Serial Commands.
Type Command Name
Bar Code Configuration <BCCFG> Enter Bar Code Configuration
Calibration
<@CAL>Calibrate
<@OPTIC> Initiate Lens Calibration
Counters
<N> No Read Counter
<O> No Read Counter Reset
<T> Trigger Counter
<U> Trigger Counter Reset
<V> Good Read/Match Counter
<W> Good Read/Match Counter Reset
<X> Mismatch Counter
<Y> Mismatch Counter Reset
Default/Reset/Save
<A> Software Reset – Retain Current Parameters
<Ard> Software Reset – Recall Factory Defaults
<Arp> Software Reset – Recall Power-On Defaults
<Arc> Software Reset – Recall Customer Defaults
<Z>
Software Reset – Save Current Settings for Power-On
<Zc>
Software Reset – Save Current Settings as Customer
Defaults
<Zrd>
Software Reset – Recall Factory Defaults and Save
for Power-On
<Zrc>
Software Reset – Recall Customer Defaults and
Save for Power-On
Device Control
<L1> Programmable Output 1
<L2> Programmable Output 2
<L3> Programmable Output 3
<I> Disable Imager
<H> Enable Imager
<#> Display All Part Numbers
<#a> Display Application Code Part Number
<#b> Display Boot Code Part Number
<#d> Display DSP Code Part Number
Firmware/Checksum <#k> Display Kernel Code Part Number
<#s> Display SafeMode Part Number
<#.> Display All Firmware Build Numbers
<#a.> Display Application Code Build Number