User`s manual

QX Hawk Industrial Imager User’s Manual 7-3
Utilities
<#b.> Display Boot Code Build Number
<#d.> Display DSP Code Build Number
<#k.> Display Kernel Code Build Number
Firmware/Checksum <!> Display All Available Firmware Checksums
<!a> Display Application Code Code Checksum
<!d> Display DSP Code Checksum
<rb,key> Roll Back Application Code
Imager Status
<?> Imager Status Request
<K?> All Status Request
<K??> All Descriptor Request
<K?#> All Range Request
<Knnn?> Single Status Request
<Knnn??> Single Descriptor Request
<Knnn?#> Single Range Request
<Knnnd> Single Command Default
Learn
<LEARN> Initiate Learn Operation
<UNLEARN> Initiate Unlearn Operation
<LEARN?> Display Learn Status
Master Database
<G> Store Next Decoded Symbol to Database Index 1
<Gn> Store Next Decoded Symbol to Database Index n
<NEWM> New Master Load Status
Read Rate
<C> Enter Decodes/Second Test
<Cp> Enter Decode Percent Test
<J> Exit Decodes/Second and Decode Percent Tests
Reboot System <reboot> Cold Boot System from Boot Code
Static Validation <VAL> Perform Static Validation of Data Matrix Symbol
Targeting
<l1> Activate Targeting System
<l0> De-activate Targeting System
Temperature <@TEMP> Display Image Sensor Temperature
Y-Modem Transfer
Options
<uy
,path and image file
name>
Y-Modem Upload
<dy,image file name> Y-Modem Download (Image)
<dy,key> Y-Modem Download (Code)