User`s manual

7-20 QX Hawk Industrial Imager User’s Manual
Firmware
Request Build Number by Serial Command
Note: X = base part number; R = revision number; B = build number
• When <#.> (a request for all part numbers) is sent, the imager returns:
<#a/35-XXXXXX-RR.BBB><#b/35-XXXXXX-RR.BBB><#d/35-XXXXXX-RR.BBB>
<#k/35-XXXXXX-RR.BBB><#p/35-XXXXXX-RR.BBB>.
• When <#a.> (a request for the application code build number) is sent, the imager returns:
<#a/35-XXXXXX-RR.BBB>.
• When <#b.> (a request for the boot code build number) is sent, the imager returns:
<#b/35-XXXXXX-RR.BBB>.
• When <#d.> (a request for the DSP code build number) is sent, the imager returns:
<#d/35-XXXXXX-RR.BBB>.
• When <#k.> (a request for the kernel code build number) is sent, the imager returns:
<#k/35-XXXXXX-RR.BBB>.
• When <#p.> (a request for the system configuration file build number) is sent, the
imager returns:
<#p/35-XXXXXX-RR.BBB>.