User`s manual

A-36 QX Hawk Industrial Imager User’s Manual
Serial Commands
Ambles to Source
Echo to Source
Output at End of Read Cycle
Output at ETX
Output at Timeout
Array Communication Modes
Mode
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: CR (0x0D)
Options: Any 7-bit ASCII character
Serial Cmd: <K161,mode,destination port,ambles to source,echo to source,output at
end of read cycle,output at ETX,output at timeout>
Default: 200 (x10 ms = 2 seconds)
Options: 0 – 65535
Serial Cmd: <K162,mode,source,daisy chain i.d. status,daisy chain i.d.>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Daisy Chain