User`s manual

A-54 QX Hawk Industrial Imager User’s Manual
Serial Commands
Serial Verification
Serial Command Echo Status
Serial Command Beep Status
Control/Hex Output
Beeper
Diagnostics Output 3 <K792,unused,service unit>
Symbol Quality Output 1
<K800,Output on Symbol Contrast,Symbol Contrast Threshold,
Output on Print Growth,Print Growth Threshold,Output on Axial
Non-Uniformity,Axial Non-Uniformity Threshold,Output on
Unused ECC,Unused ECC Threshold>
Symbol Quality Output 2
<K801,Output on Symbol Contrast,Symbol Contrast Threshold,
Output on Print Growth,Print Growth Threshold,Output on Axial
Non-Uniformity,Axial Non-Uniformity Threshold,Output on
Unused ECC,Unused ECC Threshold>
Symbol Quality Output 3
<K802,Output on Symbol Contrast,Symbol Contrast Threshold,
Output on Print Growth,Print Growth Threshold,Output on Axial
Non-Uniformity,Axial Non-Uniformity Threshold,Output on
Unused ECC,Unused ECC Threshold>
Output 1 Parameters <K810,output on,output state,pulse width,output mode>
Output 2 Parameters <K811,output on,output state,pulse width,output mode>
Output 3 Parameters <K812,output on,output state,pulse width,output mode>
Serial Cmd: <K701,serial command echo status,serial command beep status,
control/hex output>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K701,serial command echo status,serial command beep status,
control/hex output>
Default: 0 = Disabled
Options: 0 = Disabled 1 = Enabled
Serial Cmd: <K701,serial command echo status,serial command beep status,control/hex
output>
Default: 0 = Control
Options: 0 = Control 1 = Hex
Serial Cmd: <K702,beeper status>
Default: 1 = Good Read
Options: 0 = Disabled 1 = Good Read 2 = No Read