Technical data

MANUAL JI REV 1.6 EN.DOC 31.01.07 A.J.
3
Assembly
To ensure the international protection IP66 (NEMA 4X) the joystick module has to be installed in
a housing min. certified according to IP65 (with a cut-out of 153mm x 84mm and/or 6“ x 3.3“).
The joystick module is inserted into the housing cut-out with its front side to the exterior and
fastened from the inside via a minimum of four mounting clips which are evenly distributed
over the external circumference of the joystick housing in such a way that the module is tight
fitting.
The electrical connection can be seen in the wiring diagram #10100470 and the license.
Pin Connections
Connection Significance
K44-1 and/or brown and/or 1 Supply circuit +UB
K44-2 and/or white and/or 2 Supply / Data circuit GND
K44-3 and/or yellow and/or 3 Data
K44-4 and/or green and/or 4 Clock
Please find the pin numbering in the pin identification plate which is attached near the pin.
Details can be found in the wiring diagram #10100470 and the license.