742-7 Phoenix S Instruction Manual

6. Install the pushrod to connect the servo
arm and the surface control horn for each
part of the main wings.
7. Assemble the main wings with the bar
connected. Make sure you hear a click
sound to secure the main wings to the
fuselage.
8. Place the battery into the fuselage
preset position. Completely read the
following instructions before you power on
the airplane. After all set, cover on the
canopy to the fuselage.
6 / 12
Center the Control Surfaces
With the transmitter turned on and the Lipo flight battery connected to the ESC(and
installed in the battery compartment), it is now possible to connect the pushrods to the
control surfaces and to center the surfaces.
First, be sure to center the elevator, rudder and aileron trim levers. See the “Digital
Trims” section for more information. With the trim levers centered, carefully spread open
each clevis so that you can insert the pin in the hole on each control horn. It may be
helpful to use a flat blade screwdriver(not included) into the clevis then carefully twist it
until it disengages the pin from the hole in the clevis.