WARNING The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not be properly followed, will create a possibility of physical property damage AND or possibility of injury. WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating.
Boat Batteries Installation 2 open 1 3 Unlock Lock 1. Rotate the hatch of the hull cover by clockwise to unlock the hatch. 2. Open the hull cover. 3. Adhere included loop tape or velcro tape to the battery. 4. Secure the boat battery on the hook strip in the boat. 5. Secure the battery in the hull with the hook and loop strap as shown. Check Radio System CAUTION: Always keep all body parts, hair and dangling or loose items away from a spinning propeller, as these can be entangled.
WARNING: DO NOT TURN OFF THE TRANSMITTER BEFORE UNCONNECTING BATTERY OF RECEIVER, OR THE RECEIVER MAY PICK UP STRAY SIGNALS AND RUN OUT OF CONTROL TO CAUSE ACCIDENT! NOTICE: Always store the boat with hatch removed to prevent mold and mildew growth inside the hull. Test Your Boat in Water 1. Carefully place the boat in water. 2. Operate the boat at slow speed near the shoreline. Avoid objects in water at all time. 3.
Maintenance Always replace the shaft when it is damaged or shows visible wear or injury and property damage may result. Lubricating the shaft is vital to the life of the drivetrain. The lubricant also acts as a water seal, keeping water from entering the hull through the stuffing box. Lubricate the shaft, propeller shaft and all moving parts after every 2-3 hours of operation. Always replce an parts that show visible wear or damage. 1. Loosen the coupling between the motor and the shaft. 2.
Check List Before Boating - Install fully charged batteries in your boat and transmitter. - Connect the boat battery to ESC. - Make sure the boat is bound to the transmitter(otherwise, bind the boat to the transmitter using the included binding instructions.) - Make sure all linkages move freely on the boat. - Ensure the motor mount is secured to the hull so that the motor stays steady. - Perform a Control Direction Test with the transmitter. - Adjust the steering rate on your transmitter as needed.
Power Adaptor Balance Charger Lithium Battery For balance charger & power adaptor set 1. Plug the included balance charger to the power adaptor, then plug the power adaptor into a compatible AC outlet(depends on different contries and area) , then connect the power output lead to the receptacle on the side of the balance charger The power adapter and balance charger are powered on when the green color LED indicator is glowing. 2.
Troubleshooting Guide Problem Boat does not respond to throttle but responds to other controls Extra noise or extra vibration Possible Cause Throttle servo travel is lower than 100% Throttle channel is reversed Damaged propeller, shaft or motor Propeller is out of balance Boat battery charge is low Boat battery is damaged Reduced runtime or boat underpowered Blocking or friction on shaft or propeller Boat conditions may be too cold Battery capacity may be too low for conditions Drive dog is too close Bo
Problem Possible Cause Solution Move powered transmitter a few feet from Transmitter is too near boat during boat, disconnect and reconnect battery to linking process boat Boat or transmitter is too close to large Move boat or transmitter away from large metal object metal object Rebind transmitter to boat and remove bind Boat does not link (after Bind plug is left installed plug before cycling power binding) to transmitter Boat battery/transmitter battery Replace/recharge batteries charge is too low Tran
/ 12
