User guide

16 17
7. TROUBLESHOOTING
PROBLEM SOLUTION
The RF signal is not
recognized.
Check that your ActivHub
TM
is emitting RF. The blue LED
on the side of the ActivHub
TM
RF will ash 2 times quickly to
indicate that it is emitting RF.
The glasses are blinking
strongly.
Check that there is no other
source using the same RF
channel within a range
of 30 meters around the
ActivHub
TM
RF.
The glasses blink when
I turn them ON
When this phenomenon
occurs, it means that
the battery is low. Please
recharge the glasses.
The EDGE™ RF glasses
are not synchronizing
with the ActivHub
TM
RF50
Verify that the RF channel
selected under the
ActivHub
TM
RF is set to
position “8”. Check that
your original source is
broadcasting 3D.
The EDGE™ RF glasses
stay OFF despite the
fact that I press the
ON/OFF button to turn
them ON
Try recharging your glasses. If
the problem persists, contact
[e-mail]
Advanced :
Delta Sync (μs) : Modify the sync offset (between -2000
and 2000 microseconds). Default = 0
3D Sync :
Choose time of the free wheel to eventually win more
autonomy
Moves sensibility :
Choose the sensibility of the glasses move sensor
Auto-OFF on moves :
Choose time before glasses shut down if there is no
movement
Auto-OFF on sync :
Choose the time before shut down if the glasses doesn’t
receive any 3D sync signal
Low level battery :
Choose the treshold that determines that the battery is
low