User Manual

PLAYING MP3’S FROM A USB FLASH DRIVE OR MICRO SD CARD

1. Switch the power on.

2. Insert USB ﬂash disk or micro SD card into the slot. The music stored will be played automatically.

3. Music tracks can be selected with the control buttons on the speaker.

Press FM+ /

or FM- / Button to select songs you would like to play.

4. To fast forward to a song section, press and hold the FM+ /

Button while scrolling to your

desired section. To rewind to a song section, press and hold the FM- /

Button to scroll back to

your desired section.

5. Press AUTO SCAN

Button to play or pause the music.

6. Use the VOL+ and VOL- Buttons on the speaker to adjust the volume accordingly.

7. Press REP/CH Button to replay the song again when ﬁnished.

Note: In Bluetooth mode, inserting a USB ﬂash disk will disconnect the Bluetooth and switch to

playing from the USB ﬂash disk. Press the MODE Button to switch back to Bluetooth mode.

AUX-IN

1. Press MODE Button to cycle the speaker to Aux mode.

2. Plug the provided audio cable into the compatible device’s “line-out or headphone-out” and then

into the “Aux-in” of the speaker.

FM RADIO

1. Use the provided audio cable as an antenna to receive a good FM radio signal.

2. Once the device has been turned on, press the MODE Button to cycle to FM radio mode.

3. Use the AUTO SCAN

Button to search for all available FM channels and store them

automatically.

4. To navigate between radio stations, use the FM+ /

or FM- / Buttons to select radio stations.

Note: Inserting the audio cable while the speaker is in FM mode, will cause the speaker to

automatically switch to Aux mode. Pressing the MODE Button again will cycle back to FM mode.