Repair Manual

7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
451
"DO NOT" INSTALL
THIS BOLT
452
453
451 CENTER SUPPORT RETAINING BOLTS (6 REQUIRED).
452 CENTER SUPPORT BOLT LOCKING TABS (6 REQUIRED).
453 CENTER SUPPORT ASSEMBLY.
Figure 172
Copyright © 2010 ATSG
103
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
13. Install the completed final drive assembly, as
shown in Figure 173.
14. Install the completed transfer gear/pinion gear
assembly, as shown in Figure 173.
Continued on Page 104
11. Install the completed center support assembly,
as shown in Figure 172, by rotating back and
forth into position.
12. Install five of the six center support retaining
shown in Figure 172, and hand tighten only the
five installed bolts.
Note: The sixth bolt cannot be installed until
the park rod guide is installed, as the guide
must go under the parking pawl. We will install
the last bolt and torque all bolts, after the park
rod guide is installed.
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
900
960
900 FINAL DRIVE ASSEMBLY.
960 TRANSFER DRIVEN GEAR AND PINION GEAR ASSEMBLY.
Figure 173
TRANSAXLE FINAL ASSEMBLY (CONT'D)
WWW.ALL-TRANS.BY