Repair Manual

8
Continued on Page 108
107
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
7
10
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
Figure 179
131
134
133
132
REAR VIEW
120 NUMBER 5 THRUST BEARING RACE.
131 K1 CLUTCH HOUSING ASSEMBLY.
132 NUMBER 6 THRUST BEARING.
133 NUMBER 6 THRUST BEARING RACE.
134 K3 CLUTCH HOUSING DRIVE HUB.
Copyright © 2010 ATSG
28. Install the B1 clutch "stepped" pressure plate, as
shown in Figure 178, with "step" facing down.
29. Install B1 clutch pack beginning with a friction
plate onto the pressure plate and alternating with
a steel plate, as shown in Figure 178, until you
have installed the proper quantity, as the quantity
may vary.
Note: All friction plates should be soaked in
proper fluid for 30 minutes before installing.
30. Install the B1 clutch backing plate on top of the
last friction, as shown in Figure 178, with the
rounded edge facing the friction.
Note: Notice the number stamped on top side
of backing plate, which is an indicator that it
is selective, but no selectives available as yet.
31. Install the B1 clutch "bellville" cushion plate in
the direction shown in Figure 178.
Note: There is no backing plate snap ring for
the B1 clutch pack. We will check B1 clutch
clearance before installing oil pump, as the
apply piston is in the oil pump assembly. The
apply piston caged return spring assembly sits
between the piston and cushion plate, retaining
the B1 clutch pack.
32. Install K3 clutch housing drive hub, as shown in
Figure 179, and engage on splines of sun gear.
33. Install the number 6 thrust bearing race into the
drive hub, as shown in Figure 179.
34. Install the number 6 thrust bearing with needles
facing down, as shown in Figure 179.
35. Install completed K1 clutch housing, as shown
in Figure 179.
36. Ensure that number 5 thrust bearing race is still
in place on K1 clutch housing, as shown in
Figure 179.
TRANSAXLE FINAL ASSEMBLY (CONT'D)
120
WWW.ALL-TRANS.BY