Repair Manual

40. Install the B1 clutch apply ring and return spring
assembly, as shown in Figure 181.
Note: Return spring assembly goes around the
outside diameter of K3 clutch housing and
seats on B1 clutch cushion spring.
108
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
113
111
7
8
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
Copyright © 2010 ATSG
Figure 180
111 NUMBER 2 THRUST WASHER.
113 FRONT PLANETARY ASSEMBLY.
119 NUMBER 5 THRUST BEARING.
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
420
100
Copyright © 2010 ATSG
Figure 181
100 K3 CLUTCH HOUSING ASSEMBLY.
420 B1 CLUTCH APPLY RING AND RETURN SPRING ASSEMBLY.
Continued on Page 109
37. Install the completed front planetary assembly,
as shown in Figure 180, ensuring that number 5
thrust bearing and number 2 thrust washer are
still in place.
38. Front planetary assembly must be rotated back
and forth to engage K1 clutch frictions into the
planetary hub until fully seated.
39. Install K3 clutch housing assembly, as shown in
Figure 181, by rotating back and forth until it is
fully seated.
Note: K3 clutch frictions must engage on the
front planet hub, K3 clutch housing must be
engaged into B1 frictions and drive hub.
TRANSAXLE FINAL ASSEMBLY (CONT'D)
119
REAR VIEW
WWW.ALL-TRANS.BY