Repair Manual

AU
FA
AU
F
A
VW G
A
VW G
A
GGZ 280303
0 0283C 162T
G 0 035 3 0 09 H
5 4 2
7 - 034
51
140
-
1
-
T
6803
C
12 02
O
Z
0
0 53 0 3 H
90
G
0410
136
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
Copyright © 2010 ATSG
Figure 185
Figure 186 Figure 187
Copyright © 2010 ATSG
Transaxle End Play
Should be Approximately
0.52 MM (.020")
110
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
TRANSAXLE FINAL ASSEMBLY (CONT'D)
46. Install "H" gage on transaxle pump surface, as
shown in Figure 185, lower the adjustment rod
to the surface of the number 1 thrust washer on
the K3 clutch housing and tighten adjustment
rod locking knob.
47. Now turn the "H" gage over and set it on the
completed oil pump assembly, "with" the new
design gasket and number 1 thrust washer in
place, as shown in Figure 186.
48. Measure with feeler gauge between adjustment
rod and the number 1 thrust washer, as shown in
Figure 186, to determine transaxle end-play.
49. Transaxle end-play should be approximately
0.52 MM (.020").
Note: Currently there are no selective thrust
washers available.
50. Install new manual shaft seal using the proper
seal driver (See Figure 187).
Continued on Page 111
136 MANUAL SHAFT SEAL.
WWW.ALL-TRANS.BY