Repair Manual

115
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
Figure 197
30 OUTPUT SPEED SENSOR AND HARNESS ASSEMBLY.
31 INPUT SPEED SENSOR AND HARNESS ASSEMBLY.
32 SENSOR AND SWITCH HARNESS OVER PAN RAIL.
33 14 WAY SOLENOID HARNESS OVER PAN RAIL.
43 OUTPUT SPEED SENSOR RETAINING BOLT (18 MM LENGTH).
44 INPUT SPEED SENSOR RETAINING BOLT (22 MM LENGTH).
30
31
33
32
43
44
Output Speed
Sensor Location
Input Speed
Sensor Location
Copyright © 2010 ATSG
Figure 198
SOME
MODELS
ONLY
39 B1 ACCUMULATOR PISTON.
40 B1 ACCUMULATOR PISTON INNER SPRING (SOME MODELS).
41 B1 ACCUMULATOR PISTON OUTER SPRING.
42 B1 ACCUMULATOR PISTON SPRING.
39
40
41
42
39
Copyright © 2010 ATSG
TRANSAXLE FINAL ASSEMBLY (CONT'D)
70. Install the output speed sensor, as shown in
Figure 197, and torque bolt to 7 N·m (62 in.lb.).
Note: This bolt has 8 mm head, 18 mm long.
71. Install the input speed sensor, as shown in
Figure 197, and torque bolt to 10 N·m (88 in.lb.).
Note: This bolt has 10 mm head, 21 mm long.
72. Install the B1 accumulator springs and piston
into the case as shown in Figure 198.
Note: The number of B1 accumulator springs
will vary depending on year and model.
Continued on Page 116
WWW.ALL-TRANS.BY