Repair Manual

116
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
Figure 199
Copyright © 2010 ATSG
30 OUTPUT SPEED SENSOR HARNESS OVER PAN RAIL.
31 INPUT SPEED SENSOR HARNESS OVER PAN RAIL.
32 SENSOR AND SWITCH HARNESS OVER PAN RAIL.
33 14 WAY SOLENOID HARNESS OVER PAN RAIL.
34 VALVE BODY TO CASE BOLT (16 MM LENGTH).
35 VALVE BODY TO CASE BOLT (21 MM LENGTH).
36 VALVE BODY TO CASE BOLT (28 MM LENGTH).
37 WIRE HARNESS RETAINING BRACKET.
38 WIRE HARNESS RETAINING BRACKET.
0
917
1T
7C 0 0A
3C0 7 8
A3 007 47C C 0
0 3 15B 3A 1 7Y
1 65 X3 0 7B A 0
5CB3B0 004 0
4A 0 0U3C0 1 0
34
35
35
35
35
35
35
36
36
36
36
38
37
34
30
31
33
32
GAU6A06894
DCB6A09064
FBX6A08574
ABY6A09412
CCP6A09214
CCP6A09212
9170
T1
EO
Figure 200
C
C
C
C
A
A
B
B
B
B
C
C
A = 16 mm Length
B = 28 mm Length
C = 21 mm Length
VALVE BODY TO CASE BOLTS
Copyright © 2010 ATSG
Wire Harness
Bracket
Wire Harness
Bracket
TRANSAXLE FINAL ASSEMBLY (CONT'D)
73. With all wire harness' laid over pan rail, install
the completed valve body assembly onto case, as
shown in Figure 199.
74. Install the 12 valve body to case bolts and wire
the wire harness retaining brackets, as shown in
Figure 199.
Note: Wire harness retaining brackets will vary
from model to model.
75. Torque all valve body to case retaining bolts to
9 N·m (80 in.lb.) (See Figure 200).
Continued on Page 116
WWW.ALL-TRANS.BY