Repair Manual

Solenoid
Number (Name)
Positive Meter Lead
Terminal No. (Wire Color)
Solenoid No. 1 (N88)
Solenoid No. 2 (N89)
Solenoid No. 3 (N90)
Solenoid No. 4 (N91)
Solenoid No. 5 (N92)
Solenoid No. 6 (N93)
Solenoid No. 9 (N282)
Solenoid No. 10 (N283)
1 (White)
2 (Black)
7 (Lt. Blue)
11 (Lt. Green)
3 (Yellow)
13 (Green)
5 (Red)
9 (White)
Negative Meter Lead
Terminal No. (Wire Color)
Case Ground
Case Ground
8 (Lt. Green)
12 (Brown)
4 (Purple)
14 (Grey)
6 (Blue)
10 (Black)
Ohms
Resistance
10.0 - 16.0
10.0 - 16.0
4.0 - 8.0
4.0 - 8.0
4.0 - 8.0
4.0 - 8.0
4.0 - 8.0
4.0 - 8.0
When comparing resistance readings of On/Off solenoids, the resistance should be within .5 Ohms of one another.
When comparing resistance readings of PWM solenoids, the resistance should be within .5 Ohms of one another.
RESISTANCE CHART THROUGH 14-WAY CASE CONNECTOR
Temperature F° (C°)
-22°F (-30°C)
50°F (10°C)
77°F (25°C)
77°F (25°C)
77°F (25°C)
230°F (110°C)
293°F (145°C)
37K - 51K Ohms
5K - 8K Ohms
3K - 5K Ohms
230 - 265 Ohms
100 - 120 Ohms
Sensor
ID (Name)
Positive Lead
Term. No. (Color)
TFT (G93)
ISS (G182)
OSS (G195)
PS1 (G193)
PS2 (G194)
1 (Orange)
3 (White)
5 (Tan)
7 (N/A)**
8 (N/A)**
6 (Blue)
Case Ground
Case Ground
4 (Red)
Negative Lead
Term. No. (Color)
2 (Orange)
Ohms
Resistance
5.0M Ohms*
5.0M Ohms*
0 = Open
0 = Open
* The ISS and OSS are Hall Affect Sensors and should be checked using a scope under operating conditions. The resistance values provided in
the chart are from new sensors. Resistance checks on these type of sensors would, at best, inform you of either open or grounded circuits within
the sensor itself.
** Both pressure switches were eliminated in all 09G transaxles from June 2004 on.
RESISTANCE CHART THROUGH 8-WAY CASE CONNECTOR
18
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
Wire colors provided in these charts are "Internal" colors.
Figure 21
WWW.ALL-TRANS.BY