Repair Manual

TRANSAXLE DISASSEMBLY (CONT'D)
5. Remove the 2 transaxle range switch retaining
bolts and range switch, as shown in Figure 51.
Note: The contact lever adjusting nut must
not be loosened (See Figure 51).
6. Remove the integral cooler (if equipped) and
set aside for flushing.
7. Remove and discard the 2 filter seals (4) & (6),
as shown in Figure 51.
Note: Notice that some models are equipped
with a flow control distributor pipe in the
supply side of cooler, as shown in Figure 51.
Continued on Page 44
AU
FA
AU
FA
V
A
GW
VW A
G
0
0
GGZ 2
8 3 3
0 23
T0 1
8
C 2 6
09G 0 H 3
0 3
50
5 3
07 44 2-
1 -4
5 -
0 1 1
603
2 8C T021
O
Z
03
3 5
H00
09
G
1
00 4
For flow control, a distributor pipe is
installed into the supply side of the
Integral Cooler on some models only.
NOTE: Do not install distributor pipe in
the return side of the Integral Cooler.
2 TRANSAXLE RANGE SWITCH.
3 TRANSAXLE RANGE SWITCH RETAINING BOLTS (2 REQUIRED).
4 INTEGRAL COOLER TO CASE SPECIAL "O" RING SEAL.
5 INTEGRAL COOLER ASSEMBLY.
6 "O" RING SEAL.
7 FLAT WASHER.
8 CONE SHAPED LOCKING WASHER.
9 INTEGRAL COOLER RETAINING BOLT.
10 INTEGRAL COOLER FLOW CONTROL PIPE (SOME MODELS).
2
CONTACT LEVER
ADJUSTING NUT
3
4
5
6
7
8
9
10
Figure 51
43
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY