Repair Manual

29. Remove the retaining bolt from 8-way connector
and carefully remove the 8-way connector and
wiring harness assembly, through the case bore,
as shown in Figure 63.
Note: Remove and discard the case connector
"O" ring and temp sensor "O" ring.
30. Remove retaining bolt from 14-way connector
and carefully remove the 14-way connector and
wiring harness assembly through the case bore,
as shown in Figure 63.
Note: Remove and discard the case connector
"O" ring.
32 8-WAY CASE CONNECTOR AND HARNESS ASSEMBLY.
33 14-WAY CASE CONNECTOR AND HARNESS ASSEMBLY.
45 CONNECTOR RETAINING BOLT (11 MM LENGTH FROM WASHER).
46 8-WAY CONNECTOR TO CASE "O" RING SEAL.
47 14-WAY CONNECTOR TO CASE "O" RING SEAL.
48 TEMP SENSOR TO VALVE BODY "O" RING SEAL.
AU
FA
AU
FA
VW AG
V AGW
0
0
GGZ 2
8 3 3
0 23
T0 1
8
C 2 6
09G 0 H 3
0 3
50
5 3
07 44 2-
-4 5 10 1 -
1
603
2 8C T021
O
Z
3
3
0 H00
5
09
G
1
004
45
45
46
47
48
33
32
Continued on Page 50
TRANSAXLE DISASSEMBLY (CONT'D)
Figure 63
49
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY