Repair Manual

7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
32
1 6 C
A
49 BOLT 30 MM LENGTH (17 REQUIRED).
50 BOLT 45 MM LENGTH (1 REQUIRED).
51 BOLT 83 MM LENGTH (1 REQUIRED).
52 STUD BOLT 30 MM LENGTH (2 REQUIRED)
33. Remove the converter housing from transaxle
case by tapping with a mallet to loosen housing
from dowels and sealant (See Figure 66).
34. Set the converter housing aside for component
rebuild section.
31. Position transaxle so that converter housing is
facing up, as shown in Figure 64.
32. Remove the 21 converter housing bolts shown in
Figure 65, using a 12 mm socket or wrench.
Note: Converter housing bolt configuration
will vary depending on model and year. Some
locations have "stud" bolts (See Figure 65).
Continued on Page 51
TRANSAXLE DISASSEMBLY (CONT'D)TRANSAXLE DISASSEMBLY (CONT'D)
Figure 65 Figure 66
Figure 64
{
{
1 Behind Bell
Housing Here
21 Total
2 Behind Bell
Housing Here
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
49
50
52
51
"B" = BOLT 83 MM LENGTH (1 REQUIRED).
"C" = BOLT 45 MM LENGTH (1 REQUIRED).
"A" = BOLT 30 MM LENGTH (17 REQUIRED.
B
A
A
A
A
A
A
A
A
A A
A
A
C
A
A
AA
D
D
50
Copyright © 2010 ATSGCopyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY