Repair Manual

AU
FA
AU
FA
VW G A
VW G A
G 2803GZ 03
0203C
8
2T 16
0G
035093 0 H
5
4 - 02734
51
1
40
- 1
-
03C
T 1682
20
O
Z
0
0
3 0
53
H
90 G
0410
136
137
140
138
139
Figure 70Figure 69
Continued on Page 53
40. Remove the "rolled" pin from the inside detent
lever using a 3/16" punch and hammer, as shown
in Figure 69.
Note: There is a safety band around the inside
detent lever that must be removed first. Only
way to get it off is to break it and discard it.
The safety band will not be reused.
41. Remove the manual shaft from the top side of
the transaxle, as shown in Figure 70, by sliding
out through the inside detent lever and the case
bore.
42. Remove the inside detent lever and park rod, as
shown in Figure 70.
43. Remove and discard the manual shaft seal in the
case, as shown in Figure 70.
TRANSAXLE DISASSEMBLY (CONT'D)
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
136 MANUAL SHAFT SEAL.
137 MANUAL SHAFT.
138 ROLLED PIN.
139 INSIDE DETENT LEVER.
140 PARKING ROD.
52
Copyright © 2010 ATSGCopyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY