Repair Manual

63. Carefully install the style of vice-grips that are
shown in Figure 82, to the splines of the small
sun gear.
64. Use the vice-grips as a handle to remove the F1
roller clutch and rear planetary gear-set as an
assembly, as shown in Figure 82, and set aside
for the component rebuild section.
65. Remove the B2 clutch backing plate snap ring,
as shown in Figure 83.
66. Remove the complete B2 clutch pack from the
transaxle case, as shown in Figure 83.
59
Copyright © 2010 ATSGCopyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
2
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
2
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
TRANSAXLE DISASSEMBLY (CONT'D)
62. Remove the snap ring retaining F1 roller clutch,
as shown in Figure 82.
Note: This snap ring is .050" in thickness.
Continued on Page 60
Figure 82 Figure 83
462 F1 ROLLER CLUTCH SNAP RING (.050" THICKNESS).
463 F1 ROLLER CLUTCH AND REAR GEAR SET ASSEMBLY.
475 B2 CLUTCH BACKING PLATE SNAP RING.
476 B2 CLUTCH COMPLETE ASSEMBLY.
462
462
475
476
WWW.ALL-TRANS.BY