Repair Manual

7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
67. Remove the K2 clutch housing assembly along
with the number 9 thrust bearing and races, as
shown in Figure 84, and set aside for component
rebuild section.
Note: Number 9 front thrust bearing race may
be stuck to the small sun gear in rear gear-set.
68. Remove the number 11 thrust bearing and race,
as shown in Figure 84.
Note: Number 11 thrust bearing may be stuck
to rear of K2 clutch housing.
7
4051 - 1 - 1
03C2T02168
Z
0300 035H
09G
1004
TRANSAXLE DISASSEMBLY (CONT'D)
Continued on Page 61
Figure 85Figure 84
60
Copyright © 2010 ATSGCopyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
471
472
473
511
480
481
512
513
471 NUMBER 9 "FRONT" THRUST BEARING RACE.
472 NUMBER 9 THRUST BEARING.
473 NUMBER 9 "REAR" THRUST BEARING RACE.
511 K2 CLUTCH HOUSING ASSEMBLY.
512 NUMBER 11 THRUST BEARING.
513 NUMBER 11 THRUST BEARING RACE.
480 B2 CLUTCH RETURN SPRING SNAP RING (.048" THICKNESS).
481 B2 CLUTCH APPLY PISTON RETURN SPRING ASSEMBLY.
69. Remove the B2 clutch return spring retaining
snap ring, as shown in Figure 85.
70. Remove the B2 clutch return spring assembly, as
shown in Figure 85.
WWW.ALL-TRANS.BY