Repair Manual

INNER GEAR TO FACE .0008" - .0015"
.0008" - .002"
.003" - .005"
COMPONENT
Oil Pump Specifications
SPECIFICATION
OUTER GEAR TO FACE
OUTER GEAR TO BODY
62
63
63
64
65
"DOTS"
FACING UP
62 OIL PUMP BODY.
63 OIL PUMP HOLLOW ALIGNMENT DOWELS (2 REQUIRED).
64 OIL PUMP OUTER GEAR, GEROTOR STYLE.
65 OIL PUMP INNER GEAR, GEROTOR STYLE.
62
66
67
62 OIL PUMP BODY.
66 OIL PUMP COVER AND STATOR SHAFT ASSEMBLY.
67 PUMP COVER RETAINING BOLTS & WASHERS (8 REQUIRED).
67
Copyright © 2010 ATSGCopyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
Continued on Page 68
COMPONENT REBUILD (CONT'D)
OIL PUMP ASSEMBLY (CONT'D)
10. Install the oil pump body alignment dowels, as
shown in Figure 99, if removed.
11. Install the oil pump inner and outer gears into
the pump body, as shown in Figure 99, with
the "dots" facing up.
12. Lubricate the gears with small amount proper
transaxle fluid.
13. Measure the gear to face clearance on both the
inner and outer gears using a feeler gage or a
depth micrometer, as shown in Figure 100.
Note: Oil Pump Specifications are also shown
in Figure 100.
14. Install the oil pump cover into the oil pump
body, as shown in Figure 101, and install the
eight bolts and washers.
Figure 99 Figure 101
Figure 100
S
t
t
a
r
t r
e
9
8
0
WWW.ALL-TRANS.BY