Repair Manual

69
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
6
100
101
102
103
104
105
106
109
108
107
110
100 K3 CLUTCH HOUSING ASSEMBLY.
101 K3 CLUTCH PISTON OUTER "O" RING SEAL.
102 K3 CLUTCH APPLY PISTON.
103 K3 CLUTCH PISTON INNER "O" RING SEAL.
104 K3 CLUTCH PISTON RETURN SPRING ASSEMBLY.
105 K3 CLUTCH BALANCE PISTON.
106 K3 CLUTCH BALANCE PISTON SNAP RING.
107 K3 CLUTCH STEEL PLATES.
108 K3 CLUTCH FRICTION PLATES.
109 K3 CLUTCH BACKING PLATE.
110 K3 CLUTCH BACKING PLATE SNAP RING (.064" THICK).
K3 CLUTCH EXPLODED VIEW
COMPONENT REBUILD (CONT'D)
K3 CLUTCH HOUSING ASSEMBLY
Figure 106
1. Disassemble the K3 clutch housing assembly
using Figure 106 as a guide.
2. Clean all K3 clutch housing parts thoroughly
and dry with compressed air.
3. Inspect all K3 clutch housing parts thoroughly
for wear and/or damage, replace as necessary.
WARNING: At time of this printing, there are not
any new "hard parts" available from the
manufacturer for this unit. The only source will be
used aftermarket suppliers.
Continued on Page 70
WWW.ALL-TRANS.BY