Repair Manual

8
121
122
125
126
127
128
129
130
131
132 133
134
123
124
REAR VIEW
120 NUMBER 5 THRUST BEARING RACE.
121 K1 CLUTCH BACKING PLATE SNAP RING, 1.62MM (.064") THICK.
122 K1 CLUTCH BACKING PLATE.
123 K1 CLUTCH FRICTION PLATES (QUANTITY WILL VARY).
124 K1 CLUTCH STEEL PLATES (QUANTITY WILL VARY).
125 K1 CLUTCH BALANCE PISTON SNAP RING.
126 K1 CLUTCH BALANCE PISTON.
127 K1 CLUTCH APPLY PISTON RETURN SPRING ASSEMBLY.
128 K1 CLUTCH APPLY PISTON.
129 K1 CLUTCH INNER "O" RING SEAL.
130 K1 CLUTCH OUTER "O" RING SEAL.
131 K1 CLUTCH HOUSING ASSEMBLY.
132 NUMBER 6 THRUST BEARING.
133 NUMBER 6 THRUST BEARING RACE.
134 K3 CLUTCH HOUSING DRIVE HUB.
K1 CLUTCH HOUSING AND RELATED PARTS, EXPLODED VIEW
Figure 111
72
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
COMPONENT REBUILD (CONT'D)
K1 CLUTCH HOUSING ASSEMBLY
1. Disassemble the K1 clutch housing assembly
using Figure 111 as a guide.
2. Clean all K1 clutch housing parts thoroughly
and dry with compressed air.
3. Inspect all K1 clutch housing parts thoroughly
for wear and/or damage, replace as necessary.
WARNING: At time of this printing, there are not
any new "hard parts" available from the
manufacturer for this unit. The only source will be
used aftermarket suppliers.
Continued on Page 73
120
WWW.ALL-TRANS.BY