Repair Manual

471
472 473
500
501
504
505
506
507
508
509
510
511
512 513
502
503
471 NUMBER 9 "FRONT" THRUST BEARING RACE.
472 NUMBER 9 THRUST BEARING.
473 NUMBER 9 "REAR" THRUST BEARING RACE.
500 K2 CLUTCH BACKING PLATE SNAP RING (.065" THICKNESS).
501 K2 CLUTCH BACKING PLATE, .114".
502 K2 CLUTCH FRICTION PLATES (QUANTITY MAY VARY).
503 K2 CLUTCH STEEL PLATES , .071" (QUANTITY MAY VARY).
504 K2 CLUTCH BALANCE PISTON SNAP RING.
505 K2 CLUTCH "MOULDED" BALANCE PISTON.
506 K2 CLUTCH APPLY PISTON RETURN SPRING ASSEMBLY.
507 K2 CLUTCH APPLY PISTON RETURN SPRING SEAT.
508 K2 CLUTCH "MOULDED" APPLY PISTON.
509 K2 CLUTCH BALANCE PISTON INNER "O" RING SEAL (THIN).
510 K2 CLUTCH APPLIY PISTON INNER "O" RING SEAL (THICK).
511 K2 CLUTCH HOUSING ASSEMBLY.
512 NUMBER 11 THRUST BEARING.
513 NUMBER 11 THRUST BEARING RACE.
K2 CLUTCH AND ASSOCIATED PARTS, EXPLODED VIEW
COMPONENT REBUILD (CONT'D)
K2 CLUTCH HOUSING ASSEMBLY
1. Disassemble the K2 clutch housing assembly
using Figure 120 as a guide.
2. Clean all K2 clutch housing parts thoroughly
and dry with compressed air.
3. Inspect all K2 clutch housing parts thoroughly
for wear and/or damage, replace as necessary.
WARNING: At time of this printing, there are not
any new "hard parts" available from the
manufacturer for this unit. The only source will be
used aftermarket suppliers.
Continued on Page 77
Figure 120
76
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY