Repair Manual

K2 CLUTCH HOUSING ASSEMBLY (CONT'D)

4. Install the K2 apply piston inner "O" ring seal

in the bottom groove of housing, as shown in

Figure 121.

Note: Body of this "O" ring measures .105".

5. Install the K2 balance piston inner "O" ring

seal in the center groove of housing, as shown

in Figure 121.

Note: Body of this "O" ring measures .055".

6. Install the K2 return spring assembly to the

spring seat, as shown in Figure 122, and retain

with Trans-Jel®.

COMPONENT REBUILD (CONT'D)

AUTOMATIC TRANSMISSION SERVICE GROUP

Technical Service Information

504 K2 CLUTCH BALANCE PISTON SNAP RING.

505 K2 CLUTCH "MOULDED" BALANCE PISTON.

506 K2 CLUTCH APPLY PISTON RETURN SPRING ASSEMBLY.

507 K2 CLUTCH APPLY PISTON RETURN SPRING SEAT.

508 K2 CLUTCH "MOULDED" APPLY PISTON.

511 K2 CLUTCH HOUSING ASSEMBLY.

506 K2 CLUTCH APPLY PISTON RETURN SPRING ASSEMBLY.

507 K2 CLUTCH APPLY PISTON RETURN SPRING SEAT.

509 K2 CLUTCH BALANCE PISTON INNER "O" RING SEAL (THIN).

510 K2 CLUTCH APPLIY PISTON INNER "O" RING SEAL (THICK).

511 K2 CLUTCH HOUSING ASSEMBLY.

511

506

505

504

507

508

507

510

509

7. Lubricate the seal surfaces of K2 clutch apply

piston and install the piston into K2 clutch

housing, as shown in Figure 123

8. Install K2 clutch piston return spring assembly,

as shown in Figure 123.

9. Lube the balance piston seal and install piston,

as shown in Figure 123.

10. Compress the balance piston and install the

snap ring, as shown in Figure 123.

Figure 121

Figure 122 Figure 123

Continued on Page 78