Repair Manual

Copyright © 2010 ATSG
471
DO NOT
INSTALL
472
473
15. Turn the K2 clutch housing assembly over and
install the number 11 thrust bearing, as shown
in Figure 126, with the needles facing up.
16. Retain the number 11 thrust bearing with liberal
amount of Trans-Jel®.
17. Turn the K2 clutch housing assembly over again
and install the number 9 "rear" thrust bearing
race, as shown in Figure 127, and retain with a
small amount of Trans-Jel®.
18. Install the K2 clutch housing number 9 thrust
bearing, as shown in Figure 127, and retain with
Trans-Jel®.
Note: "Do Not" install the number 9 "front"
thrust bearing race (471) illustrated in
Figure 127. This will be installed on the rear
sun gear of the rear planetary.
19. Set the completed K2 clutch housing aside for
the final assembly process.
K2 CLUTCH HOUSING ASSEMBLY (CONT'D)
COMPONENT REBUILD (CONT'D)
Component Rebuild
Continued on Page 80
79
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
473
511
511 K2 CLUTCH HOUSING ASSEMBLY.
512 NUMBER 11 THRUST BEARING.
Copyright © 2010 ATSG
COMPLETED K2 CLUTCH HOUSING
Figure 126 Figure 128
Figure 127
471 NUMBER 9 "FRONT" THRUST BEARING RACE.
472 NUMBER 9 THRUST BEARING.
473 NUMBER 9 "REAR" THRUST BEARING RACE.
511 K2 CLUTCH HOUSING ASSEMBLY.
WWW.ALL-TRANS.BY