Repair Manual

8
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
GAU6A06894
DCB6A09064
FBX6A08574 ABY6A09412
CCP6A09214
CCP6A09212
9173
T5
EO
Pressure Switch 2
Location (G194)
(If Used)
Pressure Switch 1
Location (G193)
(If Used)
Transaxle Fluid
Temperature Sensor
Retaining Bracket
Transaxle Fluid
Temperature Sensor (G93)
Location
PRESSURE SWITCH AND TEMP SENSOR LOCATIONS
ELECTRONIC COMPONENTS (CONT'D)
Pressure Switches 1 (G193) And 2 (G194)
Some 09G/09M transaxles are equipped with two
pressure switches that screw into the valve body
casting in the locations shown in Figure 7. Both
switches are "normally open" switches that connect to
ground when pressure exceeds approx. 44 psi and are
used to verify valve movement in the valve body
assembly.
Pressure Switch 1 (G193) is used to verify activation
of the K-1 clutch.
Pressure Switch 2 (G194) is used to verify activation
of the B-2 clutch. Therefore, pressure switch 2 is
closed in tiptronic mode only, 1st gear. The only other
time the B-2 clutch is required is in reverse (R) gear.
Pressure Switch 2 does not close in the reverse
position, as reverse is engaged by the manual valve
hydraulically.
Note: Both pressure switches were eliminated in all
09G transaxles from June 2004 on.
TRANSAXLE FLUID TEMP SENSOR (G93)
Temperature F° (C°)
-22°F (-30°C)
50°F (10°C)
77°F (25°C)
230°F (110°C)
293°F (145°C)
Resistance
37K - 51K Ohms
5K - 8K Ohms
3K - 5K Ohms
230 - 265 Ohms
100 - 120 Ohms
"O" RING
FLUID TEMP
SENSOR
Figure 8
Figure 7
WWW.ALL-TRANS.BY