Repair Manual

REAR PLANETARY ASSEMBLY (CONT'D)

COMPONENT REBUILD (CONT'D)

Sun Gear

Shafts

Number 8

Thrust Bearing

Blocks

4. Place the rear planetary carrier on a flat work

surface, as shown in Figure 130.

5. Install the number 7 thrust washer, as shown in

Figure 130, and retain with Trans-Jel®.

Note: This is the only "bronze" washer.

6. Install the F1 roller clutch onto the planetary

carrier, as shown in Figure 130, by rotating

carefully in a counter-clockwise direction until

fully seated.

7. Turn the rear carrier assembly over and place

on a set of appropriate blocks with front side

facing down, as shown in Figure 131.

Note: The rear carrier must be placed on the

blocks as shown, to allow the front sun gear

and shaft to seat on the inside of the carrier.

If sun gear is not down, the number 8 thrust

bearing and front race will not seat properly,

and it must seat into a pocket cut in the front

sun gear.

Refer to the cut-away in Figure 132.

Figure 132Figure 130

Blocks

Figure 131

463

464

465

463 F1 ROLLER CLUTCH ASSEMBLY.

464 NUMBER 7 THRUST WASHER (BRONZE).

465 REAR PLANETARY "RAVIGNEAUX" GEAR SET.

Continued on Page 82

AUTOMATIC TRANSMISSION SERVICE GROUP

Technical Service Information