Repair Manual

Blocks
465
466
1 1/8
470
465 REAR PLANETARY "RAVIGNEAUX" GEAR SET.
466 NUMBER 10 THRUST WASHER (PLASTIC).
470 COMPLETED REAR SUN GEAR.
Figure 135 Figure 137
Figure 136
Blocks
1 1/8
1 - 1/8"
Socket
1 - 1/8"
Socket
REAR PLANETARY ASSEMBLY (CONT'D)
COMPONENT REBUILD (CONT'D)
12. Install the completed sun gear assembly into
rear planetary carrier, as shown in Figure 135,
by rotating into position.
13. Place a 1-1/8", 1/2" drive socket on the rear
sun gear, as shown in Figure 136.
14. Gently roll the complete assembly over while
holding the socket in place until the planetary
assembly is setting upright on the socket, as
shown in Figure 137.
Note: This will retain the seated position of
the two sun gears.
15. Carefully place the vice-grips on the splines of
rear sun gear and against the shoulder of the
front sun gear, as shown in Figure 137, and set
the complete assembly aside for final assembly.
Component Rebuild
Continued on Page 84
83
Copyright © 2010 ATSG
Copyright © 2010 ATSG
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY