Repair Manual

INSTALLED ON

K1 CLUTCH

HOUSING

118

119

120

135

118 FRONT PLANETARY RING GEAR AND INPUT SHAFT ASSEMBLY.

119 NUMBER 5 THRUST BEARING.

120 NUMBER 5 THRUST BEARING RACE.

135 K1 CLUTCH SEALING RINGS (2 REQUIRED).

114

113

113 FRONT PLANETARY CARRIER ASSEMBLY.

114 NUMBER 4 THRUST WASHER.

118

117

117 NUMBER 3 THRUST BEARING RACE.

118 FRONT PLANETARY RING GEAR AND INPUT SHAFT ASSEMBLY.

FRONT PLANETARY ASSEMBLY (CONT'D)

COMPONENT REBUILD (CONT'D)

Figure 139 Figure 141

Figure 140

4. Install the number 5 thrust bearing onto back

side of input shaft and front planet ring gear, as

shown in Figure 139, with needles facing up

and retain with Trans-Jel®.

Note: Number 5 thrust bearing race already

installed on K1 clutch housing.

5. Install two new sealing rings into the grooves

of input shaft, as shown in Figure 139.

6. Turn assembly over and install the number 3

thrust bearing race, as shown in Figure 140,

and retain with Trans-Jel®.

7. Install number 4 thrust washer on back side of

front planetary carrier, as shown in Figure 141,

and retain with Trans-Jel®.

Note: This washer is included in Trans-Tec®

rebuild kit.

Continued on Page 86

AUTOMATIC TRANSMISSION SERVICE GROUP

Technical Service Information