Repair Manual

246
246
249
249
250
250
355
356
357
358
359
360
361
362
363
364
365
366
367
368
369
369
370
370
371
371
372
372
373
373
374
374
375
375
245
245
245
245
"09G" ACCUMULATOR 1, EXPLODED VIEW
245 ACCUMULATOR-1 HOUSING TO UPPER V.B. (52 MM LENGTH)(4 REQ).
246 ACCUMULATOR-1 HOUSING TO UPPER V.B. (64 MM LENGTH)(2 REQ).
249 ACCUMULATOR-1 HOUSING ASSEMBLY.
250 ACCUMULATOR-1 ASSEMBLY SPACER PLATE.
355 TCC REGULATOR BOOST VALVE SLEEVE RETAINER.
356 TCC REGULATOR BOOST VALVE SLEEVE.
357 TCC REGULATOR BOOST VALVE.
358 TCC REGULATOR VALVE SPRING.
359 TCC REGULATOR VALVE.
360 SOLENOID REGULATOR VALVE BORE PLUG RETAINER.
361 SOLENOID REGULATOR VALVE BORE PLUG.
362 SOLENOID REGULATOR VALVE FOR N91, N92, N93.
363 SOLENOID REGULATOR VALVE SPRING.
364 LINE PRESSURE ACCUMULATOR PISTON.
365 LINE PRESSURE ACCUMULATOR PISTON OUTER SPRING.
366 LINE PRESSURE ACCUMULATOR PISTON INNER SPRING.
367 LINE PRESSURE ACCUMULATOR SPRING RETAINER PLATE.
368 ACCUMULATOR PISTON RETAINER BOLTS (11 MM LENGTH).
369 CHECK BALL, 5.3 MM (.210") DIAMETER.
370 PRESSURE CONTROL SOLENOID (N93) LIMIT VALVE.
371 PRESSURE CONTROL SOLENOID (N93) LIMIT VALVE SPRING.
372 B1 CLUTCH PRESSURE LIMIT VALVE (.392" DIAMETER).
373 B1 CLUTCH PRESSURE LIMIT VALVE SPRING.
374 COOLER PRESSURE LIMIT VALVE (.392" DIAMETER).
375 COOLER PRESSURE LIMIT VALVE SPRING.
Figure 159
VALVE BODY ASSEMBLY (CONT'D)
COMPONENT REBUILD (CONT'D)
26. Disassemble the accumulator 1 valve body and
place valves, springs and retainers on appropriate
trays exactly as they were removed, as shown in
Figure 159.
Note: All accumulator body pistons are the
same, but the accumulator springs should be
tagged for identification.
27. Clean all accumulator body parts thoroughly and
dry with compressed air.
Continued on Page 97
28. Inspect all accumulator body parts thoroughly
for any wear and/or damage.
29. Assemble the valves, springs, bore plugs and
retainers exactly as shown in Figure 159, and
lube with proper ATF as they are installed.
Note: Use small amount of Trans-Jel® on the
flat retainers, to prevent them from falling out,
as all valves are not spring loaded.
96
Copyright © 2010 ATSG
AUTOMATIC TRANSMISSION SERVICE GROUP
Technical Service Information
WWW.ALL-TRANS.BY