Repair Manual

917

9170

Figure 162Figure 160

355 TCC REGULATOR BOOST VALVE SLEEVE RETAINER.

356 TCC REGULATOR BOOST VALVE SLEEVE.

245 ACCUMULATOR-1 HOUSING TO UPPER V.B. (52 MM LENGTH)(4 REQ).

246 ACCUMULATOR-1 HOUSING TO UPPER V.B. (64 MM LENGTH)(2 REQ).

AUTOMATIC TRANSMISSION SERVICE GROUP

Technical Service Information

917

Figure 161

246

245

355

356

VALVE BODY ASSEMBLY (CONT'D)

COMPONENT REBUILD (CONT'D)

30. The TCC regulator boost valve sleeve has a slot

for the retainer on only one side of the sleeve, as

shown in Figure 160, and must be rotated to the

proper position to accept the retainer.

31. Turn the accumulator body over and install the

check valves and the check ball, as shown in

Figure 159.

32. With the small parts in place, install the spacer

plate onto the accumulator body, as shown in

Figure 159.

33. Again using your hand as a clamp, hold spacer

plate against the accumulator body, turn the

assembly over and install it onto upper valve

body, as shown in Figure 161, and install proper

retaining bolts.

Note: Valve body bolt lengths are shown in the

legend.

34. Just "snug" the retaining bolts at this time, as

shown in Figure 162.

Continued on Page 99