Repair Manual

ManualsBrandsVOLKSWAGEN ManualsAutomotiveVolkswagen 09G-09M Automatic Transmission Repair Manual.pdf

100

917

9170

VALVE BODY ASSEMBLY (CONT'D)

COMPONENT REBUILD (CONT'D)

Continued on Page 100

35. Disassemble the accumulator 2 valve body and

place valves, springs and retainers on appropriate

trays exactly as they were removed, as shown in

Figure 163.

Note: All accumulator body pistons are the

same, but the accumulator springs should be

tagged for identification.

36. Clean all accumulator body parts thoroughly and

dry with compressed air.

37. Inspect all accumulator body parts thoroughly

for any wear and/or damage.

38. Assemble the valves, springs, bore plugs and

retainers exactly as shown in Figure 163, and

lube with proper ATF as they are installed.

Note: Use small amount of Trans-Jel® on the

flat retainers, to prevent them from falling out,

as all valves are not spring loaded.

39. Install the accumulator pistons and springs, as

shown in Figure 163, install the retainer plate

and "snug" the bolts at this time.

40. Turn the accumulator body over and install the

check valves, as shown in Figure 163.

41. With the small parts in place, install the spacer

plate onto the accumulator 2 body, as shown in

Figure 163.

42. Again using your hand as a clamp, hold spacer

plate against the accumulator body, turn the

assembly over and install it onto upper valve

body, as shown in Figure 164, and install proper

retaining bolts.

43. Torque all accumulator housing retaining bolts

on both accumulator housings as follows:

Retaining Bolts = 9 N·m (80 in.lb.).

Piston Retainer Bolts = 7 N·m (62 in.lb.).

Figure 164

Figure 165

9170

243

247

243

244

243 ACCUMULATOR 2 HOUSING TO UPPER V.B. (64 MM LENGTH)(3 REQ).

244 ACCUMULATOR-2 HOUSING TO UPPER V.B. (52 MM LENGTH)(4 REQ).

247 ACCUMULATOR-2 HOUSING AND SPACER PLATE ASSEMBLY.

AUTOMATIC TRANSMISSION SERVICE GROUP

Technical Service Information