SI4463S9S-V1-C2A SUB-1G Wireless Module SI4463S9S-V1-C2A Wireless Module Hardware Specifications V01 Company: Shenzhen Vollgo Technology co., Ltd Address: No.
SI4463S9S-V1-C2A SUB-1G Wireless Module directory 1. Overview ...................................................................................................................................... 1 2. Technical parameters .................................................................................................................... 2 3. Pin Assignments ........................................................................................................................... 3 4. Pin Description .....
SI4463S9S-V1-C2A SUB-1G Wireless Module 1. Overview Si4463SXS series wireless module, based on Silicon Labs Si4463 C version of high-performance wireless transceiver chip design, is a small size, low power consumption, long-distance two-way wireless transceiver module. SI4463 is one of the ISM band wireless transceiver chips launched by Silicon Labs, with industry-advanced RF performance.The module integrates all RF related functions and devices.
SI4463S9S-V1-C2A SUB-1G Wireless Module 2. Technical parameters Characteristics Parameter Chip Si4463-C2A-GMR Supply Voltage Range 1.8 V to 3.
SI4463S9S-V1-C2A SUB-1G Wireless Module 3. Pin Assignments 3 www.vollgo.
SI4463S9S-V1-C2A SUB-1G Wireless Module 4. Pin Description Pin Pin Name I/O Description 1 VCC - +1.8 to +3.8V Supply Voltage Input to Module The recommended VCC supply voltage is +3.
SI4463S9S-V1-C2A SUB-1G Wireless Module 5. Recommended Connection of Hardware Figure 5-1 Hardware Connection Antenna Path design: The following figure gives an overview of a design with Ipex connector for antenna and soldering for Integral Antenna. Figure 5-2: RF module Test Board The antenna path must be designed with a 50 OHMS line inserted into The ground plane for better performance. Antenna must be kept away from any metal part like batteries, etc... for better performance. 5 www.vollgo.
SI4463S9S-V1-C2A SUB-1G Wireless Module 6. Revision History Revision V01 Comment Ddate First release October 4, 2019 Author 7. Document Statement 1. Due to product version upgrade or other reasons, this document will be updated from time to time.Unless otherwise agreed, this document is intended as a guide to use only, and all statements, information and recommendations contained in this document do not constitute any warranty, express or implied. 2.
SI4463S9S-V1-C2A SUB-1G Wireless Module ---Increase the separation between the equipment and receiver. ---Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ---Consult the dealer or an experienced radio/TV technician for help. WARNING: Changes or modifications not expressly approved by the party responsible for the compliance could void the user's authority to operate the equipment.
SI4463S9S-V1-C2A SUB-1G Wireless Module uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
SI4463S9S-V1-C2A SUB-1G Wireless Module LABELING AND USER INFORMATION REQUIREMENTS OF THE END PRODUCT: The Industry Canada certification label of a module shall be clearly visible at all times when installed in the host device, otherwise the host device must be labeled to display the Industry Canada certification number of the module, preceded by the words “Contains transmitter module”, or the word “Contains”, or similar wording expressing the same meaning, as follows: Contains IC: 26935-VG63S9SC2A or Cont
SI4463S9S-V1-C2A SUB-1G Wireless Module General Statements The module is limited to OEM installation only. The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install module.
