Specifications

SI4463S9S-V1-C2A SUB-1G Wireless Module
7
www.vollgo.com
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for help.
WARNING: Changes or modifications not expressly approved by the party
responsible for the compliance could void the user's authority to operate the
equipment.
LABELING AND USER INFORMATION REQUIREMENTS OF THE END PRODUCT:
The final end product must be labelled in a visible area with the following
“Contains TX FCC ID: 2AYT2-VG63S9SC2A” or “Contains Transmitter Module
FCC ID: 2AYT2-VG63S9SC2A”. If the size of the end product is smaller than
8x10cm, then additional FCC part 15.19 statement is required to be
available in the users’ manual: This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
A user's manual for the finished product should include one of the
following statements:- For a Class A digital device or peripheral, the
instructions furnished the user shall include the following or similar
statement, placed in a prominent location in the text of the manual:
This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at
his own expense.
- For a Class B digital device or peripheral, the instructions furnished
the user shall include the following or similar statement, placed in a
prominent location in the text of the manual:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,