User Manual
Foodservice induction ranges
OperatOr’s Manual
Top View Front View
C
A
B
E
F
D
Unit Cutout Dimensions for Drop-in Models
A
14-11/16” (37.0 cm)
B
13-3/8” (34.0 cm)
C
11-3/4” (30.0 cm)
D
12-11/16” (32.0 cm)
E
1/4 (.63 cm)
F
Countertop
Control Cutout Dimensions for Drop-in Models
A
N/A
B
5” (12.7 cm)
C
2
11
\16
” (6.9 cm)
D
N/A
E
N/A
F
Countertop
3. Seal the joint between the induction warmer and countertop.
4. Plug the power cord into a grounded electrical outlet with the matching
nameplate rated voltage.
oPeration
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
If liquid spills or boils over onto the unit, immediately unplug the unit
and remove cookware. Wipe up any liquid with a padded cloth.
1. Place the induction-ready cookware containing food in the center position
of a heating surface.
2. Press the ON/OFF button. The DISPLAY panel will show a power level
or the HEAT DISPLAY LED will light. When an induction ready cookware
pan is placed on the heating surface, the DISPLAY panel will remain on,
or the HEATING LED will illuminate. This indicates the unit is heating.
Do not touch cookware, heating surface, food, or
liquid while heating.
Hot food and liquids can burn skin. Induction heating surfaces heat
very rapidly. Use caution when adding pre-heated oil, liquid or other
food already in the cookware.
Units with DISPLAY panels are equipped with an “over-heating protection”
feature. If the temperature of the cooking surface becomes too hot, the unit
will turn off. The display will ash “F2” to indicate the unit is in “over-heating
protection” mode. After the unit has cooled, turn the cooking surface on and if
“F2” is not displayed, then cooking can resume.
The display window should remain constant during operation. If the display is
ashing, see the section in this manual.
Removing cookware from the cooking surface for more than ve minutes will
cause the unit to automatically turn off. Removing cookware for less than ve
minutes will not interrupt operation of the unit.
All units will start in Power Mode when turned on rst time.