User manual

VoloFone™ VF100 User Manual

Voice Services

To use the VoloFone™ VF100 as a wireless telephone connection:

 Plug the phone lead into the RJ11 (Phone) port on the back of the VoloFone™ VF100.

 Lift the handset (you should hear a dial tone) and dial the number you wish to call. The Phone Light

on the front of the VoloFone™ VF100 will flash when the handset is off-hook.

If Power-on PIN Lock has been enabled, the dial tone will be different (an intermittent tone instead

of the normal dial tone). Unlock the SIM using the telephone keypad by entering the PIN followed by

# then replace the handset.

VoloAdmin™

This section covers the administration of the VoloFone™ VF100. There are many configurable features;

however, it is only necessary to configure one setting to make your VoloFone™ VF100 work.

The setting that you need to configure is:

APN (Access Point Name)

If your VoloFone™ VF100 was purchased as a packaged unit including a configured USIM, you do

not need to configure the APN.

It is recommended that even if you have a pre-configured unit, you complete the next step and record

the APN. This is to save time obtaining it from your service provider in the event it is lost due to a

configuration error or a reset some time in the future.

What is the Access Point Name? – The APN is the name of your ISP’s wireless access point.

To configure the APN for your ISP, start by loading VoloAdmin™ as described above.

 From the Navigation panel on the left select Quick Setup - the Quick Setup page appears:

 Enter the name of your ISP’s Access Point in the editbox provided.

 Click the Apply button.

The Test Button

On many of the configuration pages a Test button is present. Use the Test button to test the functionality

that you have just configured. When you are satisfied with the new configuration, click the Apply button.

Clicking the Apply button saves any changed settings permanently in non-volatile memory.