User manual

VoloFone™ VF100 User Manual

VoloFone™ VF100 Connections

The following diagram shows the rear panel of the VoloFone™ VF100 and describes the purpose of each

connection.

Antenna (RF) – attach the supplied antenna to this connector.

Serial port – this is used for diagnostic/maintenance purposes/reserved for future use.

USB (Universal Serial Bus) port – this is used for diagnostic/maintenance

purposes/reserved for future use.

Ethernet port (LAN) – plug a network cable in here. The Link light (green) denotes a

network connection. The Activity light (yellow) denotes network traffic.

Phone port (RJ11) – connect a phone here.

Power Supply – connect the power supply cable here.

Reset Button – Use a paper clip to reset the VoloFone™ VF100. See below for

further information on resetting the VoloFone™ VF100.

Resetting the VoloFone™ VF100

The unit can be reset at any time after the first LEDs sequence appears after a power cycle. This is done by

pressing and holding down the reset button (use a paperclip to do this). The VoloFone™ acknowledges the

reset button press using its front panel LEDs:

1. LEDs turn red - first acknowledgment of reset button press.

2. LEDs turn green - 5 seconds after first acknowledgment.

3. LEDs turn red again - 10 seconds after first acknowledgement.

The reset button of the VoloFone™ VF100 has three functions:

1. Reboot the VoloFone™ VF100

Press and hold the reset button down for a period between the first and second indications; that is, less

than 5 seconds (between the first red LEDs and the green LEDs indication).

This is equivalent to cycling the power of the VoloFone™ VF100 by unplugging it from the battery base (if

applicable) and unplugging the power supply.