Installation Instructions

RF remote vontroller
1. Press ON/Off key to turn on/off.
2. Press Hi/Mid/Low for setting selection
3. Instant press ‘OFF’ to show status
4. Press ‘OFF’ 4s to turn off.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital
device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not installed and
used in accordance with the instructions,may cause harmful interference to radio
communications.However,there is no guarantee that interference will not accor in a particular
installation.if this equipmemt does cause harmful interference to radio or television reception,which
can be determined by turning the equipment off and on,the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from that to which the receiver is
connectec.
• Consult the dealer or an experienced radio/TV technician for help.