User Manual

Instruction Manual
Read instructions before using this transformer
One Year Warranty
We guarantee each new transformer to be free from
defects in material or workmanship and to perform under
normal use and service. This guarantee shall run for a
period of one year from the date of purchase and obliga-
tions under this guarantee are limited to remedying any
defect or replacing any defective part and shall be effec-
tive only if the defective unit is returned to us within 12
months after purchase. Damage due to abuse, misuse or
overloading is not covered by this guarantee. We shall
not be responsible for any other loss or damage that may
arise through the use by a purchaser or others of this
device and the purchaser assumes such responsibility
and will hold Hybrinetics, Inc. harmless in respect to all
such loss or damage.
Important: This is a factory direct warranty. Do not
return defectives to your retailer. All defectives must be
returned to the factory accompanied by a sales receipt
with the original date of purchase. For more informa-
tion please call our toll free number [phone].
Voltage Valet Division, Hybrinetics, Inc.
225 Sutton Place, Santa Rosa, CA 95407
www.voltagevalet.com
© 2007 HYBRINETICS, INC.
50 vs. 60 Hz
Step Up/Step Down Transformers ONLY convert voltage, they
do not convert cycles (Hz). Motorized appliances designed to
operate on 60 Hz may operate differently when used on 50 Hz
power sources. Check with the appliance manufacturer before
using a 60 Hz motorized appliance on a 50 Hz power source.
Motorized Appliances
At start up the current demand of a motorized appliance surges increas-
ing the wattage required 50% to 200% above it's listed wattage rating.
OPERATING INSTRUCTIONS
1. Place the transformer on a firm, flat surface.
2.
Be sure the ON/OFF power switch is in the “OFF” position before
plugging (or unplugging) the power cord into a 110-120VAC or
220-240VAC power source. NOTE: In some countries a Voltage
Valet Grounded Adaptor Plug will be needed to connect to 220-
240VAC power sources (see grounded adaptor plug list).
3. Step Up Mode: Set the INPUT VOLTAGE SELECTOR switch
to 120VAC for use with 220-240VAC appliances in countries
with 110-120VAC power sources. Be sure your appliance
ON/OFF switch is in the “OFF” position and fully insert your
220-240VAC appliance plug into the 240VAC receptacle.
NOTE: Use grounded adaptor plug, model GUB, to modify
the 240VAC receptacle to fit most foreign 220-240 volt appli-
ance plugs (except the South African 15 amp).
4. Step Down Mode: Set the INPUT VOLTAGE SELECTOR switch
to 240VAC for use with 110-120VAC appliances in countries
with 220-240VAC power sources. Be sure your appliance ON/
OFF switch is in the “OFF” position and fully insert your 110-
120VAC appliance plug into the 120VAC receptacle.
Model TGC300
300 Watt Maximum Load
Model TGC500
500 Watt Maximum Load
Model TGC1000
1000 Watt Maximum Load
Model TGC2000
2000 Watt Maximum Load
Step Up Mode: Input 110-120VAC 60 Hz
Output 220-240VAC 60 Hz
Step Down Mode: Input 220-240VAC 50 Hz
Output 110-120VAC 50 Hz
5. Turn the transformer's ON/OFF power switch to the “ON”
position. You are ready to use your appliance. NOTE:
Due to
the constant reversing of the AC current flowing through it,
this transformer may produce an audible hum when turned
on. This is normal and will not harm the transformer or any
appliance plugged into it.
MAINTENANCE AND CLEANING
DO NOT IMMERSE THE TRANSFORMER INTO WATER OR ANY
OTHER LIQUID.
1. Before cleaning, disconnect the appliance from the electrical
outlet. Allow to cool completely.
2. Clean transformers by wiping with a soft damp cloth. Do not
use abrasive or harsh cleaning agents. No other maintenance
is required.
3. Store transformer where it will not be damaged. Do not wrap
cord around transformer.
4. Do not attempt to repair the transformer yourself. Return to
Voltage Valet for service.
Grounded Adaptor Plugs
The Voltage Valet Step Up/Step Down Transformer includes a
North American grounded appliance plug. A grounded adaptor
plug may be needed to connect to 220-240VAC power sources.
Contact your Voltage Valet dealer for adaptors listed below.
VOLTAGE VALET™
Step Up/Step Down Transformer
GUB Continental Europe, 4.8mm
GUC Australia/New Zealand/China
GUD United Kingdom/Hong Kong
GUE South Africa/India, 15 Amp
GUF India/Middle East, 5 Amp
GUI Italy
GUL Israel
GUR Russia, 4.0 mm
GUS Switzerland
HYB880_TGC_Instr.indd 1 9/17/07 10:52:47 AM