User manual

The desired programme is selected with the selection buttons “<“ or “>”. Five different

programmes are available.

“SET CHARGE” = Charge

“SET DISCHARGE” = Discharge (no maintenance charge!)

“SET CHECK” = Discharge -> charge

“SET CYCLE” = Charge -> discharge -> charge

“SET ALIVE” = Charge -> discharge -> charge -> discharge -> charge

• “CHA” (“CHARGE”) means that the inserted battery is being charged.

• “DIS” (“DISCHARGE”) means that the inserted battery will only be discharged. There is

no maintenance charge.

• “CHK” (“CHECK”) means that a charge follows the discharge.

• “CYC” (“CYCLE”) means that the inserted battery will be first charged, then discharged

and finally recharged.

• “ALV” (“ALIVE”) means that the battery must go through several charge and discharge

cycles. The “ALIVE” programme is used for activating new batteries and batteries that

were stored for an extended period of time.

Depending on the programme selected, you may also have to choose the matching charge

current.

Charge current input

Use the arrow buttons to select the charge current first. This is also either assumed by the

button “OK” or automatically after five seconds.

Without any input, the “Charge Manager 410” will set the charge current to 500 mA

automatically.

SLOT1 PROG CHA

SET I-CHA 500mA