User manual
24
4. INTENDED USE
Theconverterproducesasine-shapedalternatingvoltageof225V/ACat50Hzfromadirectvoltage(dependingon
converter version, either with a rated voltage of 12 V/DC or 24 V/DC).
12 V/DC 24 V/DC
Itemno.511316(SW-4000) Itemno.511290(SW-4000)
Itemno.511258(SW-2000) Itemno.511257(SW-2000)
Itemno.511755(SW-1200) Itemno.511756(SW-1200)
Itemno.511747(SW-600) Itemno.511748(SW-600)
Itemno.511745(SW-300) Itemno.511746(SW-300)
Itemno.511743(SW-150) Itemno.511744(SW-150)
Itemno.511700(SW-100) -
The mains voltage the inverter produces has a true sine shape. Therefore, the inverter also may be used to operate
sensitive consumers that react to irregularities in the voltage supply with interferences.
The maximum output of the inverter and other important indices can be found in chapter "Technical Data" at the end
of these operating instructions.
Electrical consumers with a higher rated power intake than the maximum permanent output of the inverter must not
be connected.
Whenconnectinganelectricalconsumer(e.g.drill,refrigerator,etc.),totheconverter,observethatitoftenneedsa
higher output than indicated on the rating plate of the consumer for a short period when switching on or starting up.
Theconverterthereforebrieysuppliesahigheroutput.Italsooffersasoftstartfunction.
The converter also has an undervoltage pre-warning and a deactivation at undervoltage or short circuit. There also
is a protection against polarity reversal and an overtemperature protection.
The safety notes and all other information in these operating instructions always have to be observed! Read these
operating instructions with care before connection and commissioning. Keep these operating instructions or pass
them on to a third party only together with this product.
Any use other than that described above can damage the product and may involve additional risks such as short
circuit,re,electricshock,etc.Nopartofthisproductmustbemodiedorconverted!
This product complies with the statutory national and European requirements.