User manual

"NUMBER OF CELLS "

"3 CELLS = 6.0V "

"6 CELLS = 12.0V "

If required, change the cell number by using the UP or DOWN key and confirm your

selection by pressing the OK button.

Now, the nominal capacity indicated on the accumulator is to be selected. You can

set it in the range of between 1.0Ah and 44Ah by pressing the UP and DOWN keys.

Please note that warranty will lapse if you select a false capacity. Any claim to war-

ranty will lapse in such a case for the charging station (and of course for the accu-

mulator).

First, the integral capacity from 1 to 44 Ah is to be entered.

"SET CAPACITY "

" 1.xAh "

" 44.xAh "

If the capacity is lower than 10Ah, the fractional digit can be set in steps of 100mAh

then.

"CAPACITY "

" 4.2Ah "

Now, the type of accumulator is to be selected.

Two different types of accumulators can be charged:

- standard lead accumulators (e.g. used in vehicles and older motorbikes) and

lead gel or lead fleece accumulators (e.g. used for motorbikes, model making and

alarm systems).

To give you an immediate general idea about the state of the accumulator, the cur-

rent charge status of the accumulator is displayed in percent. This value is only reli-

able, if the accumulator has not been previously charged or discharged for at least

one hour.

"SET TYPE "

"1. Pb STANDARD "

"2. SEALED PbACID"

Now select the charging program. You can select between five different pro-

grammes.