User manual

63
7. If you press the button “Start/Enter” during the discharge process, the discharge current can be
changed (see above).
8. Once the discharge process has been completed, an audio signal is emitted.
If you wish to terminate the discharge process beforehand, press the „Batt Type/Stop“
button.
15. SAVING BATTERY DATA
The charger has altogether 5 memory slots in which you can save battery data/settings.
1. In the main menu, select the function “SAVE DATA” with the button “Batt Type/Stop”.
PROGRAM SELECT
SAVE DATA
2. Press the button “Start/Enter”; the display shows the following, for example, and memory [01]
blinks:
SAVE [01] LiPo
3.7V 2000mAh
3. Select the desired memory slot with the buttons “INC” or “DEC” (1....5) and conrm your entry with
the button “Start/Enter”.
4. Now the battery type, which you can change with the buttons “INC” or “DEC” blinks on the top right
of the display. Conrm the selection by pressing the “Start/Enter” button.
5. The voltage starts to blink on the bottom left. Change this as usual using the buttons “INC” and
“DEC”, conrm the value using the “Start/Enter” button.
6. Now the battery capacity blinks on the bottom right. Set this with the buttons “INC” or “DEC” (keep
button depressed for fast changing) and conrm this with the button “Start/ Enter”.
7. Then the memory slot number blinks again.
8. Keep the button “Start/Enter” depressed for approx. 3 seconds to access the next menu, then
let the button go again immediately. The following display appears (depending on the previously
selected battery type):
NiMH CHARGE At*
CUR LIMIT 4.0A
LiPo CHARGE *
1.0A 7.4V(2S)
If you keep the button „Start/Enter“ pressed too long, the display shows „SAVE“ and the
settings are saved. Then restart the setting.
9. Briey press the button “Start/Enter”; the current value in the bottom line starts to blink.